Get to exactly the elements you need without reselecting from scratch. A selection box in Revit rarely picks up just one category. Grab a section of your model and you'll likely catch walls, doors, windows, and furniture all at once. The Filter tool sorts that out in seconds and gives you control over what stays selected.
Build faster from here on out. Join BIM Depot and put a tested asset library to work on your next project.
Make the selection
Draw a selection box around your elements. Drag left-to-right to select only elements fully inside the box, or right-to-left to catch anything the box even partially touches. This distinction matters when you're working in tight areas with overlapping geometry.
Filter it down
Go to Modify | Multi-Select tab > Filter panel > Filter. The Filter dialog lists every category currently in your selection along with a count of elements in each one.
Clear a category's checkbox to remove it from the selection, or check it to add it back in. Use Check All or Check None to speed through longer lists rather than clicking through each category one by one. Click OK, and your selection now contains only the categories you kept.
Why this matters
Filtering saves you from the trial-and-error cycle of selecting, deselecting, and reselecting elements by hand. It also reduces the risk of accidentally editing or deleting the wrong category during a bulk operation, which adds confidence to any large-scale edit.
Spend less time untangling selections and more time using a library built for speed with the BIM Depot Revit Membership.
BIM Depot is an independent provider of Revit resources and is not affiliated with, endorsed by, or sponsored by Autodesk or its subsidiaries.
